(Summary description)The plate and frame filter press is an intermittent solid-liquid evacuation configuration. The filter chamber is composed of a filter plate filter frame.
The plate and frame filter press is an intermittent solid-liquid evacuation configuration. The filter chamber is composed of a filter plate filter frame. Under the pressure of the feed pump, the material liquid is sent into the filter chambers, and the filter medium evacuates the solids and liquids. . This configuration is commonly used in chemicals, dyes, kerosene, ceramics, pharmaceuticals, sugar making, starch, paint, metallurgy and sewage treatment. It has the advantages of good evacuation results, wide practical scope, simple operation, and low investment, especially for sticky materials. Evacuation has unparalleled goodness. The filter plates of filter press manufacturers have stable performance, convenient operation, quietness, and labor-saving; the metal press cylinder is processed by seamless steel pipe, and the plastic steel filter plate is precision-casting, which is resistant to high temperature and high pressure, and durable. The filter press restraint factory is started when the number of filter plates is less than the specified life, so as not to damage the parts. Check the filter plate before feeding. The filter cloth must not show signs of folding to prevent leakage. After unloading the cake, the filter plate must be pressed. Filter press components and reducers must be adequately lubricated. The high pressure of the filter press will cause water leakage, the filtration temperature is too high, the plastic filter plate is easily deformed, and the suspension concentration should be uniform when feeding. The selection of filter cloth must meet the filtering skill requirements of the filter paddle. The new filter cloth should be tightened before manufacturing. The diameter of the openings should be smaller than the diameter of the filter plate. The cloth holes and the plate holes should be relatively concentric with the filter plate vertical chamber. The feed hole cloth should be simply attached to the cylinder wall. Otherwise, the filtration is unclear, the filtration speed is low, and the pipe is broken, and the intended filtration purpose cannot be achieved. In the initial stage of the filter press, the filter material became cloudy, forming a layer of filter cake on the filter cloth, and the filtrate became clear. If the filtrate is turbid or mixed, it is probably that the filter cloth is damaged or there is a problem between the cloth hole and the plate hole. At this time, the valve should be closed or the feed should be stopped to change the filter cloth. A small amount of leakage caused by the capillary signs of the filter cloth is allowed between the filter plates. The operation of the filter press must not be mixed, otherwise it will affect the smooth flow of the feed and the seal of the filter plate, resulting in unbalanced pressure on both sides of the filter plate and deforming and destroying the filter plate.
